Parker C1 rod seal type
  C1-type seals for hydraulic and pneumatic equipment to meet the demand for small seal structure, although the seal section and height is very small, but very good sealing effect.

  Due to the small surface sealing contact, friction is extremely small, and because of the special design, eliminating the need to support rings. C1 may be applied to compressed air lubrication medium.

1. Material:

Standard materials selected to nitrile rubber as the matrix of synthetic rubber, Shore A hardness of about 70 degrees.

For high temperature and chemical resistance of the working conditions, it is recommended to use the company FKM material Material no: V3664.

If the special requirements (temperature, velocity, for water, HFA solution, HFB and other liquid media), please contact our service department in order to recommend the right materials and structures.

2. Application:

Working pressure: ≤160bar (hydraulic)

          ≤16bar (pneumatic)

Operating temperature: -35 to + 100 ° C (hydraulic)

          -35 To + 80 ° C (air)

Surface speed: ≤0.5m / s (hydraulic)

          ≤1.0m / s (pneumatic)

  C1 seals are particularly suitable for lifting the plunger rod, valve, valve and pneumatic low speed rotor (V≤0.2m / s, P≤20bar).

When selecting a diameter of the seal, you should choose the largest possible cross-section.

3. Install:

C1-ring outer diameter larger than the normal size, to ensure the required fastening installation.

Once installed, the sealing lip diameter will ensure that the desired size. C1-ring can be easily put into the slot.

NOTE: nominal diameter ≤25mm, should open trench The seal section and slot position.